40720 Media Handler MDH: Sensor accuracy <Sensor accuracy> mm, TEC offset <TEC offset> mm, possible to load media that will not be clamped Japanese_Newspaper_OEM_Engine If the sensor accuracy is greater than the TEC offset - it makes it possible so that the device can try to clamp media, where it will not actually be covering any of the media. The device camps the media at the EXPECTED size of the media rather than the measured size. If media is specified to be 660, measured to be 654, but the clamp offset is only 2 mm. Then the clamps will only cover media smaller than 658. If the device has constant flyoffs while imaging this is probably one of the reasons. Make sure the sensor accuracy is smaller than the TEC offset. This error is reported. Sensor accuracy - This parameter holds the current sensor accuracy in mm. TEC offset - This parameter holds the TEC offset in mm. 07-Apr-2003 ..\..\ShowAllErrors.htmFirmware 1 Error Index ..\..\ShowAllCommands.htmFirmware 1 Command Index ..\..\ShowAllParameters.htmFirmware 1 Parameter Index Updated: Thu Jul 17 07:23:30 2008 PST